Learn the differences between Conventional Irons and Single-Length Irons

President and Founder of One Iron Golf, David Lake, explains the difference between conventional irons and single-length irons. Watch and find out why single-length irons just make sense! 


49 comments


  • Garry

    Are they recommended for seniors
    ———
    1 Iron Golf replied:
    Hi Garry, You can’t go wrong with any of our lines of irons since they are extremely forgiving for golfers of all skill levels. Our golf clubs are played by professional golfers and long-drive champions with extremely high swing speeds and played by senior women golfers with very low swing speeds. Let us know if you have any other questions!

    One Iron Golf <https://1irongolf.com>


  • Andrew

    Hi, I am a tall left-handed Golfer. 6’ 4” tall. My wrist to floor measurement comes in at 41” to 41-1/2”. Will the 39” and up be too short for me? I don’t want to have to bend over more than I should. I also have large hands and prefer larger straighter grips. What would you recommend for me? Thanks, Andrew.
    ———
    1 Iron Golf replied:
    Hi Andrew! The club length per your w-t-f measurement will ensure that the clubs fit you properly. Our grips are jumbo (1/8” oversize) with a reduced taper. Let me know if you have any questions. Check out recent reviews from other customers who are tall. 🙂

    One Iron Golf <https://1irongolf.com>


  • Tom

    Are the irons forged to where you can change the lie?
    ———
    1 Iron Golf replied:
    Hi! All of our irons are cast. The forging process is vastly inferior to the casting process in that there is little consistency between irons within a set and between sets as well. Also, the forging process uses much weaker steel in order to facilitate the grinding and material removal involved which leads to the clubs going out of spec through normal play. Our golf clubs are cast from the highest-grade stainless steel in the golf industry. To our knowledge no other golf club manufacturer uses as high a grade of steel due to the increased cost.

    The 63.5º lie angle that we use in our irons is based upon the ideal swing posture, swing plane, and impact position. This lie angle is then fitted to you through club length as determined by your wrist-to-floor measurement. This precise relationship of lie angle to club length is crucial to maximum performance. If it is altered in any way the clubs will not allow you to reach your true ball striking potential and game performance.

    Since our clubheads are cast from the highest grade 431 stainless steel they should never be bent for loft/lie angle changes as this may result in the hosel breaking. Adjustments for arbitrary loft/lie angle changes are not recommended for any brand of iron since bending the hosel of a golf club creates minute stress fractures within the steel and reduces the performance as well as the lifespan of the clubhead.

    Let us know if you have any more questions!

    One Iron Golf <https://1irongolf.com>


  • Chuck

    Can you direct me to a site for more info on fitting for single length clubs ? Do you purchase driver seperatly ??
    ———
    1 Iron Golf replied:
    Hi! You can find fitting instructions here: https://1irongolf.com/pages/fitting You can add the Dark Horse Driver separately or choose a combo set of irons and woods. Please let us know if you have any questions!

    One Iron Golf <https://1irongolf.com>


  • Jim

    Do you have used left hand clubs
    ———
    1 Iron Golf replied:
    https://1irongolf.com/collections/left-hand-offerings

    Let me know if you have any questions!

    One Iron Golf <https://1irongolf.com>


Leave a comment

Please note, comments must be approved before they are published

This site is protected by hCaptcha and the hCaptcha Privacy Policy and Terms of Service apply.